Property | Value |
---|---|
Hex Value | $D2 |
Categories | |
Localizations |
|
Repeat
Overview
Executes commands
until condition
is true.
Availability: Token only available from within the Basic editor.
Syntax
Repeatcondition:commands:End:commands
Arguments
Name | Type | Optional |
---|---|---|
condition | ||
commands | ||
commands |
Location
prgm, CTL
, 6:Repeat
Description
A Repeat loop executes a block of commands between the Repeat and End commands until the specified condition is true. The condition is tested at the end of the loop (when the End command is encountered), so the loop will always be executed at least once. This means that you sometimes don't have to declare or initialize the variables in the condition before the loop.
After each time the Repeat loop is executed, the condition is checked to see if it is true. If it is true, then the loop is exited and program execution continues after the End command. If the condition is false, the loop is executed again.
Advanced Uses
When using Repeat loops, you have to provide the code to break out of the loop (it isn't built into the loop). If there is no code that ends the loop, then you will have an infinite loop. An infinite loop just keeps executing, until you have to manually exit the loop (by pressing the ON key). In the case that you actually want an infinite loop, you can just use 0 as the condition. Because 0 is always false (based on Boolean Logic), the loop will never end.
:Repeat 0
:statement(s)
:End
Each time the program enters a Repeat block, the calculator uses 35+(size of the condition) bytes of memory to keep track of this. This memory is given back to you as soon as the program reaches End. This isn't really a problem unless you're low on RAM, or have a lot of nested Repeat statements. However, if you use Goto to jump out of a Repeat block, you lose those bytes for as long as the program is running — and if you keep doing this, you might easily run out of memory, resulting in ERR:MEMORY.
Optimization
The Ans variable (last answer) is a temporary variable that can hold any variable. Ans is changed when there is an expression or variable storage or when pausing with the Pause command. It is mostly useful when you are just manipulating one variable. To use Ans just put an expression on a line by itself; it will automatically be stored to Ans. You can then change the expressions on the next line where the variable was called and put Ans there instead.
Because Repeat loops are executed at least once, you can sometimes put Ans in the condition instead of the variable.
:Repeat A
:getKey→A
:End
can be
:Repeat Ans
:getKey→A
:End
Command Timings
When deciding whether to use a Repeat loop, as opposed to a For or While loop, it's good to know how Repeat loops stack up against them. This comparison comes from the Code Timings page showing the speeds of the three different kinds of loops:
Format
Bars
Pixels
For(A,0,2000
End
4 bars + 4 pixels
36
Delvar A
While A≤2000
A+1→A
End
23 bars
184
Delvar A
Repeat A>2000
A+1→A
End
22 bars + 7 pixels
183
The general conclusion you can take away from this table is that For( loops should be used when speed is a priority, and then you should use Repeat or While loops when the appropriate circumstance comes up. Each kind of loop has its own place, so it's still good to know how to use all three of them.
Error Conditions
- ERR:INVALID occurs if this statement is used outside a program.
Related Commands
Source: parts of this page were written by the following TI|BD contributors: burr, DarkerLine, GoVegan.
History
Calculator | OS Version | Description |
---|---|---|
TI-82 | 1.0 | Added |